How to Display Your Thrilljoy PIX! Figures Safely
By OR Anime | Published: 2026-10-18
Category: How-to Guides
Learn the best way to display your Thrilljoy PIX! figures without damaging them. This guide covers wall mounting, stacking, and protection tips for your limited edition collectibles.
Quick answer
Display your Thrilljoy PIX! figures safely by mounting them on a wall with the included adhesive strip or stacking them on a clean, stable shelf away from direct sunlight and humidity.
Why PIX! figures need special care
Thrilljoy PIX! figures are designed as lightweight vinyl wall art, but their paint and limited-edition status mean they can scratch, fade, or warp if handled carelessly. Unlike standard action figures, they lack a heavy base and rely on adhesive or stacking for display.
The vinyl material can react to heat and prolonged UV exposure, causing colors to dull or the figure to soften. Keeping them in a controlled environment preserves both their look and collectible value.
Wall mounting vs. shelf stacking
Each PIX! figure comes with a pre-applied adhesive strip on the back, intended for wall mounting. This is the most space-efficient method and shows off the figure’s full design. However, the adhesive bond can weaken over time, especially in humid rooms or on textured walls.
Stacking on a shelf is safer for rotation and avoids adhesive failure, but the figures can tip over if bumped. A small acrylic riser or non-slip pad under the bottom figure adds stability.
Step-by-step safe display guide
- Choose your display location: Pick a spot away from direct sunlight, heating vents, and high humidity (bathrooms and kitchens are risky). A wall in a bedroom or living room with stable temperature works best. Common mistake: placing figures on a windowsill or near an AC vent, which causes fading or warping over time.
- Prepare the surface for wall mounting: Wipe the wall with a dry cloth to remove dust. Press the figure firmly against the wall for 30 seconds. Wait 24 hours before moving or adjusting the figure so the adhesive fully bonds. Common mistake: mounting on textured wallpaper or fresh paint, which reduces adhesion and can cause the figure to fall.
- Stack figures on a shelf (alternative method): Place the bottom figure flat on a clean, level shelf. Align the next figure’s flat edge on top, making sure the stack is straight. Limit stacks to three figures to prevent tipping. Common mistake: stacking more than three figures or placing them near the edge of a shelf where a bump can knock them over.
- Protect from dust and scratches: Use a soft, dry microfiber cloth to dust figures weekly. For wall-mounted figures, gently wipe the front without pressing on the adhesive. For stacked figures, lift them off the shelf to dust underneath. Common mistake: using wet wipes or household cleaners, which can strip the paint or leave residue on the vinyl.
Products mentioned in this guide
- Thrilljoy PIX! Beetlejuice 1988 - LE 6000 NYCC 2024 Sticker Exclusive: This limited edition Beetlejuice figure is part of a production run of 6000 and was an NYCC 2024 exclusive. Because it’s a low-run exclusive, any display damage significantly reduces its collectible value, making careful mounting or stacking essential.
Thrilljoy PIX! Beetlejuice 1988 - LE 6000 NYCC 2024 Sticker Exclusive - Thrilljoy Lord of the Rings PIX! Gandalf LE 5000 NYCC Sticker Exclusive: Gandalf comes with a Certificate of Authenticity in the form of a laser printed, spot varnished collector’s card. The card should be stored separately in a sleeve or frame rather than displayed with the figure to avoid creasing or fading.
Thrilljoy Lord of the Rings PIX! Gandalf LE 5000 NYCC Sticker Exclusive
